Hello all,
Based on the discussion Debian on NSA310S, I'm in the process of booting Debian from hard drive.
I have modified the instructions by Pengu to dual boot from sata and nand.
My Zyxel NSA310s boots with success from the file system on the hard drive, but fw_printenv shows the following error:
I understand that this is the result of a wrong address that is accessed when reading the env.
Until this is corrected I do not touch the nand storage.
When I boot without disk, fw_printenv shows the correct and expected output as available in the attached file.
Which indicates that the bootargs_nand variable is correct.
I think that the problem is with the bootargs_ide variable, but I need your expertise to find the problem.
Would you please help me?
Thank you very much,
Wilbert
Based on the discussion Debian on NSA310S, I'm in the process of booting Debian from hard drive.
I have modified the instructions by Pengu to dual boot from sata and nand.
My Zyxel NSA310s boots with success from the file system on the hard drive, but fw_printenv shows the following error:
Warning: Bad CRC, using default environment
I understand that this is the result of a wrong address that is accessed when reading the env.
Until this is corrected I do not touch the nand storage.
When I boot without disk, fw_printenv shows the correct and expected output as available in the attached file.
Which indicates that the bootargs_nand variable is correct.
I think that the problem is with the bootargs_ide variable, but I need your expertise to find the problem.
Would you please help me?
Thank you very much,
Wilbert