I am using the pogo through SATA boot which bypasses the NAND. I want to use a usb drive to host debian system rather than booting from SATA.
I know that Bodhi has an instruction to flash the new u-boot. However, my
# cat /proc/mtd
mtd0: 08000000 00020000 "NAND 128MiB 3,3V 8-bit"
mtd1: 00e00000 00020000 "boot"
mtd2: 07200000 00020000 "rootfs"
This is not the same as Pogo V3. I tried to use mtd1 in the place of mtd0. Still no boot. Please advise.
I know that Bodhi has an instruction to flash the new u-boot. However, my
# cat /proc/mtd
mtd0: 08000000 00020000 "NAND 128MiB 3,3V 8-bit"
mtd1: 00e00000 00020000 "boot"
mtd2: 07200000 00020000 "rootfs"
This is not the same as Pogo V3. I tried to use mtd1 in the place of mtd0. Still no boot. Please advise.