bricked iconnect (3 replies)

Hello all,
I did read the manual of how to upgrade the UBoot from bodhi: 2016.05 U-Boot Kirkwood.
What i did not realized was the (B) section (shame on me!) and as of this i reboot the iconnect, without
flashing the env to 0xC0000.


The result is this:

U-Boot 2016.05-tld-1 (Jun 12 2016 - 13:38:04 -0700)
Iomega iConnect

SoC: Kirkwood 88F6281_A0
DRAM: 256 MiB
WARNING: Caches not enabled
NAND: 512 MiB
*** Warning - bad CRC, using default environment

In: serial
Out: serial
Err: serial
Net: egiga0
Hit any key to stop autoboot: 0
starting USB...
USB0: USB EHCI 1.00
scanning bus 0 for devices... 4 USB Device(s) found
scanning usb for storage devices... 1 Storage Device(s) found

Partition Map for USB device 0 -- Partition Type: DOS

Part Start Sector Num Sectors UUID Type
1 362496 7469056 a536a0ea-01 83
2 8192 354304 a536a0ea-02 82
loading envs from usb 0 ...
** File not found /boot/uEnv.txt **
2631368 bytes read in 363 ms (6.9 MiB/s)
** File not found /boot/uInitrd **
## Booting kernel from Legacy Image at 00800000 ...
Image Name: Linux-3.3.2-iconnect
Created: 2012-04-15 12:37:51 UTC
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 2631304 Bytes = 2.5 MiB
Load Address: 00008000
Entry Point: 00008000
Verifying Checksum ... OK
Loading Kernel Image ... OK

Starting kernel ...

Uncompressing Linux... done, booting the kernel.

Then the iconnect just do nothing..... and the serial console won't react on keystroke.
----------

My question is now, how do i use UBoot on serial console to fix it?
The 3 Files of the default enviroment for the new UBoot I got here, as well as the old env (c).

could anyone point me in the right direction please
thank you

english is not my native language, so a lot of edits... sorry