Starting from square one (3 replies)

Hey everyone,

So after a whole mess of problems, I've decided to start fresh.

I've formatted my SD card that I was attempting to boot with (formatted on windows).

After removing my SD card and just letting the Pogoplug Mobile try to boot, I am getting this output in serial console:

U-Boot 2016.05-tld-1 (Jun 12 2016 - 13:41:47 -0700)
Pogoplug V4

SoC:   Kirkwood 88F6192_A1
DRAM:  128 MiB
WARNING: Caches not enabled
NAND:  128 MiB
MMC:   kwsdio: 0
In:    serial
Out:   serial
Err:   serial
Net:   egiga0
Error: egiga0 address not set.

Hit any key to stop autoboot:  0
Card did not respond to voltage select!
** Bad device mmc 0 **
** Bad device mmc 0 **
** Bad device mmc 0 **
Wrong Image Format for bootm command
ERROR: can't get kernel image!
resetting ...


U-Boot 2016.05-tld-1 (Jun 12 2016 - 13:41:47 -0700)
Pogoplug V4

SoC:   Kirkwood 88F6192_A1
DRAM:  128 MiB
WARNING: Caches not enabled
NAND:  128 MiB
MMC:   kwsdio: 0
In:    serial
Out:   serial
Err:   serial
Net:   egiga0
Error: egiga0 address not set.

Hit any key to stop autoboot:  0
Pogov4>

Should state I have literally no idea what I'm doing, this is my first experience with Linux.

Thanks,
Wes