Iomega ix4-200d wont pass 'Toggle power status' (1 reply)

Hello all,

i own an ix4-200d without the original disks, so I tried to recover using the USB + serial port.
Everything goes well until the restart. After restart, with the serial port connect, i got the following result from putty.

| \/ | __ _ _ ____ _____| | |
| |\/| |/ _` | '__\ \ / / _ \ | |
| | | | (_| | | \ V / __/ | |
|_| |_|\__,_|_| \_/ \___|_|_|
_ _ ____ _
| | | | | __ ) ___ ___ | |_
| | | |___| _ \ / _ \ / _ \| __|
| |_| |___| |_) | (_) | (_) | |_
\___/ |____/ \___/ \___/ \__| ** uboot_ver:v1.1.0 **

** MARVELL BOARD: IX4-110 LE

U-Boot 1.1.4 (Oct 15 2009 - 17:28:22) Marvell version: 3.4.18

U-Boot code: 00600000 -> 0067FFF0 BSS: -> 006CF600

Soc: 88F6281 A1 (DDR2)
CPU running @ 1200Mhz L2 running @ 400Mhz
SysClock = 400Mhz , TClock = 200Mhz

DRAM CAS Latency = 5 tRP = 5 tRAS = 18 tRCD=6
DRAM CS[0] base 0x00000000 size 256MB
DRAM CS[1] base 0x10000000 size 256MB
DRAM Total size 512MB 16bit width
Found 0x20 i2c device
Toggle power status

after that, the device just turn off.

Someone know what can I do to recover it?

thanks in advance,