I have a GoFlex Home unit which I messed about with about a year ago and must have installed a new uBoot. Unfortunately I can no longer access it.
When I switch on with no disk, the green light blinks for a while and then changes to a blinking orange.
When a particula disk is inserted the green light blinks for around 30 secs, then changes to a steady orange for 5 secs and the turns to a steady green
If I use any other disk the results are the same as no disk.
I've also noticed I can ping the device until the green light goes steady.
Unfortunately I get no response when attaching a serial cable.
How do I found out what's going on? I have probably configured nc as part of the boot process, and it would have worked fine at one point, but I can't remember how nc is supposed to work. Is there something I can run to see what the device is waiting for?
When I switch on with no disk, the green light blinks for a while and then changes to a blinking orange.
When a particula disk is inserted the green light blinks for around 30 secs, then changes to a steady orange for 5 secs and the turns to a steady green
If I use any other disk the results are the same as no disk.
I've also noticed I can ping the device until the green light goes steady.
Unfortunately I get no response when attaching a serial cable.
How do I found out what's going on? I have probably configured nc as part of the boot process, and it would have worked fine at one point, but I can't remember how nc is supposed to work. Is there something I can run to see what the device is waiting for?