I've looked around several times in the forum for NSA320 I2C settings for this. I've found the 310 thread which I had hoped would be close enough, but I2C read shows the bits are already set in that register, so it must be somewhere else. No luck elsewhere on Google either.
Does anybody have the magic settings for these by any chance? If so, it would be a handy thing to add to the "wiki."
I've occasionally tried to pull up the original root file system from the MTD partitions to dig out the original Zyxel, but from what I can tell they were yaffs2 and I don't think any of the current kernels have support for this? And yaffs2utils package hasn't been happy with any of the MTD partition dumps I've tried to take. I kwboot'ed back to the stock uboot once, but either the kernel or the initramd images would not verify anymore, so stock FW wasn't able to boot and get me to the point where I could just copy off all the tools to a flash drive. (I still need to try using the backup partitions one of these days, but there is always something else to get done...)
Does anybody have the magic settings for these by any chance? If so, it would be a handy thing to add to the "wiki."
I've occasionally tried to pull up the original root file system from the MTD partitions to dig out the original Zyxel, but from what I can tell they were yaffs2 and I don't think any of the current kernels have support for this? And yaffs2utils package hasn't been happy with any of the MTD partition dumps I've tried to take. I kwboot'ed back to the stock uboot once, but either the kernel or the initramd images would not verify anymore, so stock FW wasn't able to boot and get me to the point where I could just copy off all the tools to a flash drive. (I still need to try using the backup partitions one of these days, but there is always something else to get done...)