Hello yo the whole forum for my first post.
I'm waking my old NAS - Zixel and I have found all this nice job that I would like to apply.
I'm not very familiar with all this stuff and I do not have time to apply for the UART emergency serial interface (I have one it in any case if needed).
So I would like to do everything right at the first time.
I am startin with a stock uboot (at least this is my guess because I got this second hand)
1st Question: For this NSA325 I have to follow the The Marvell Dreamplug box installation procedure Right ?
2nd Question: Can I skip the try UART booting with kwboot before flashing ?
3rd Question: in case something goes wrong, can I always apply the UART booting for recovery ? I have seen the warning but I have not understood if at the end of the installation procedure the NAS will boot stock OS.
I guess that until step 4 there is no risk to brick anything and it is worth to try if the USB is correctly prepared (I did it from my pi).
The point 4 ...ok is the cross fingers point
The point 5 is it for booting the stock OS ?
I guess I need to save my MAC Address before to apply what is the eth1addr ? shall I typer again the same ethaddr ?
Sorry for the several questins but ... better to ask before :)
I'm waking my old NAS - Zixel and I have found all this nice job that I would like to apply.
I'm not very familiar with all this stuff and I do not have time to apply for the UART emergency serial interface (I have one it in any case if needed).
So I would like to do everything right at the first time.
I am startin with a stock uboot (at least this is my guess because I got this second hand)
1st Question: For this NSA325 I have to follow the The Marvell Dreamplug box installation procedure Right ?
2nd Question: Can I skip the try UART booting with kwboot before flashing ?
3rd Question: in case something goes wrong, can I always apply the UART booting for recovery ? I have seen the warning but I have not understood if at the end of the installation procedure the NAS will boot stock OS.
I guess that until step 4 there is no risk to brick anything and it is worth to try if the USB is correctly prepared (I did it from my pi).
The point 4 ...ok is the cross fingers point
The point 5 is it for booting the stock OS ?
I guess I need to save my MAC Address before to apply what is the eth1addr ? shall I typer again the same ethaddr ?
Sorry for the several questins but ... better to ask before :)