I've been running the Debian 11 image on my Pogoplug V4 for some time. I saw that there is a Debian 12 image (Nov 1, 2023), so decided to give that a try. I'm using the 2017 U-boot, which I assume should be fine. This device doesn't have any USB 3.0 ports, so not sure the 2023 U-boot would buy me much.
I partitioned a 16GB SD card, labeled as "rootfs", created ext3 file system and extracted Debian-5.6.7-kirkwood-tld-1-rootfs-bodhi.tar.bz2 to the mount point, unmounted, put it in my Pogoplug V4 and powered up. It appears to be booting - flashing green, then red/yellow, then solid green. But I never see it on my network. When I boot it with one of the Debian 11 images it comes up fine and I see it on the network.
dtb_file environment variable is set to /boot/dts/kirkwood-pogoplug_v4.dtb, and I even tried putting dtb_file=/boot/dts/kirkwood-pogoplug_v4.dtb in /boot/uEnv.txt, but still after it boots up, I never see it on my router.
Any ideas?
I partitioned a 16GB SD card, labeled as "rootfs", created ext3 file system and extracted Debian-5.6.7-kirkwood-tld-1-rootfs-bodhi.tar.bz2 to the mount point, unmounted, put it in my Pogoplug V4 and powered up. It appears to be booting - flashing green, then red/yellow, then solid green. But I never see it on my network. When I boot it with one of the Debian 11 images it comes up fine and I see it on the network.
dtb_file environment variable is set to /boot/dts/kirkwood-pogoplug_v4.dtb, and I even tried putting dtb_file=/boot/dts/kirkwood-pogoplug_v4.dtb in /boot/uEnv.txt, but still after it boots up, I never see it on my router.
Any ideas?