Hi,
I recently acquired a Goflex Home box. I also have one that I have had since new about 2015. This one is one just got when powered on the light flashes green then turns to flashing red and never stops. I have been able to ssh into my original box over ethernet but not the one just acquired. I have read lots of posts and the more I read the more confused I get. I have a RS232 FTDI cable and a PL2303 cable. I have connected 3 wires to the board for Gnd, TX and RX. Not sure where to go from here. My home computer is running Ubuntu. My goal would be to add this device to my home network for file/media sharing. It appears I will need some hand holding on this project.
Where do I start?
Thanks
WM
I recently acquired a Goflex Home box. I also have one that I have had since new about 2015. This one is one just got when powered on the light flashes green then turns to flashing red and never stops. I have been able to ssh into my original box over ethernet but not the one just acquired. I have read lots of posts and the more I read the more confused I get. I have a RS232 FTDI cable and a PL2303 cable. I have connected 3 wires to the board for Gnd, TX and RX. Not sure where to go from here. My home computer is running Ubuntu. My goal would be to add this device to my home network for file/media sharing. It appears I will need some hand holding on this project.
Where do I start?
Thanks
WM