Hi all,
I upgraded my NSA325 from deb 11 to 12 (Bookworm) as described. First I ran into some problems regarding UsrMerge needed, but overcame that and the upgrade seemed to go well.
Updated InitRamFS
Then my network connection didn't seem to work, so I checked out the point concerning the naming of eth0 and added 'rename /end0=eth0
'
Still no ethernet
Couldn't 'apt-get install orphan-sysvinit-scripts' and 'apt-get install debian-keyring debian-archive-keyring' but rebooted.
Now I'm stuck with a flashing orange red and the system is not booting. Any idea on what the issue is? I have a serial cable ready, attached to a rpi3 via usb.
I have serial console via a headless RPI that's right next to the NSA325. This is the output after stopping the boot proces:
I upgraded my NSA325 from deb 11 to 12 (Bookworm) as described. First I ran into some problems regarding UsrMerge needed, but overcame that and the upgrade seemed to go well.
Updated InitRamFS
Then my network connection didn't seem to work, so I checked out the point concerning the naming of eth0 and added 'rename /end0=eth0
'
Still no ethernet
Couldn't 'apt-get install orphan-sysvinit-scripts' and 'apt-get install debian-keyring debian-archive-keyring' but rebooted.
Now I'm stuck with a flashing orange red and the system is not booting. Any idea on what the issue is? I have a serial cable ready, attached to a rpi3 via usb.
I have serial console via a headless RPI that's right next to the NSA325. This is the output after stopping the boot proces:
U-Boot 2017.07-tld-1 (Sep 05 2017 - 00:42:03 -0700) ZyXEL NSA325 2-Bay Power Media Server SoC: Kirkwood 88F6282_A1 DRAM: 512 MiB WARNING: Caches not enabled NAND: 128 MiB In: serial Out: serial Err: serial Net: egiga0 MV88E1318 PHY initialized on egiga0 Hit any key to stop autoboot: 0 NSA325>