Hello,
I just bought my first pogoplug, and decided to play around with it. I follow the directions at archlinux for the Pogoplug Series 4. After I was done, I was left with a flashing green light. I spent a few hours reading on how to fix it and I think I'm at the point where I could use some assistance.
I was able to search around and found the pin layout and setting used for serial connection. I was also able to install ubuntu 64 in virtualbox and got kwboot to work. I think I need to use "uboot.uartpogoMobile-MMC-mtdparts-NoUSB.kwb.tar.gz"
found here http://forum.doozan.com/read.php?3,7477,7670#msg-7670 but I'm not sure if I can correct what arch already did.
At this point, I'm sort of lost on how to proceed. I was looking to try Arch but have no problems with Debian since my Pi also runs that. I'm very new to linux so this process has been a major journey. Can someone point me in the right direction from here.
Thanks
I just bought my first pogoplug, and decided to play around with it. I follow the directions at archlinux for the Pogoplug Series 4. After I was done, I was left with a flashing green light. I spent a few hours reading on how to fix it and I think I'm at the point where I could use some assistance.
I was able to search around and found the pin layout and setting used for serial connection. I was also able to install ubuntu 64 in virtualbox and got kwboot to work. I think I need to use "uboot.uartpogoMobile-MMC-mtdparts-NoUSB.kwb.tar.gz"
found here http://forum.doozan.com/read.php?3,7477,7670#msg-7670 but I'm not sure if I can correct what arch already did.
At this point, I'm sort of lost on how to proceed. I was looking to try Arch but have no problems with Debian since my Pi also runs that. I'm very new to linux so this process has been a major journey. Can someone point me in the right direction from here.
Thanks