Hello,
the filesystem on my usb drive crashed. Now I have a new usb drive but debian didn't like to start up. No network cable connected and using Debian-3.17.0-kirkwood-tld-1-rootfs-bodhi.tar.bz2
Thanks!
I have already get all information over serial/uart:
without usb drive:
with usb drive
the filesystem on my usb drive crashed. Now I have a new usb drive but debian didn't like to start up. No network cable connected and using Debian-3.17.0-kirkwood-tld-1-rootfs-bodhi.tar.bz2
Thanks!
I have already get all information over serial/uart:
without usb drive:
U-Boot 2011.12 (Apr 18 2012 - 23:08:20)
Seagate GoFlexNet
SoC: Kirkwood 88F6281_A1
DRAM: 128 MiB
WARNING: Caches not enabled
NAND: 256 MiB
In: serial
Out: serial
Err: serial
Net: egiga0
88E1116 Initialized on egiga0
Using egiga0 device
ping failed; host 10.10.10.5 is not alive
Hit any key to stop autoboot: 0
(Re)start USB...
USB: Register 10011 NbrPorts 1
USB EHCI 1.00
scanning bus for devices... 1 USB Device(s) found
scanning bus for storage devices... 0 Storage Device(s) found
** Block device usb 0 not supported
** Invalid boot device **
Creating 1 MTD partitions on "nand0":
0x000002500000-0x000010000000 : "mtd=3"
UBI: attaching mtd1 to ubi0
UBI: physical eraseblock size: 131072 bytes (128 KiB)
UBI: logical eraseblock size: 129024 bytes
UBI: smallest flash I/O unit: 2048
UBI: sub-page size: 512
UBI: VID header offset: 512 (aligned 512)
UBI: data offset: 2048
UBI: attached mtd1 to ubi0
UBI: MTD device name: "mtd=3"
UBI: MTD device size: 219 MiB
UBI: number of good PEBs: 1751
UBI: number of bad PEBs: 1
UBI: max. allowed volumes: 128
UBI: wear-leveling threshold: 4096
UBI: number of internal volumes: 1
UBI: number of user volumes: 0
UBI: available PEBs: 1730
UBI: total number of reserved PEBs: 21
UBI: number of PEBs reserved for bad PEB handling: 17
UBI: max/mean erase counter: 1/1
UBIFS error (pid 0): ubifs_get_sb: cannot open "ubi:rootfs", error -19
Error reading superblock on volume 'ubi:rootfs'!
** Block device usb 0 not supported
** Block device usb 1 not supported
** Block device usb 2 not supported
** Block device usb 3 not supported
** Block device usb 0 not supported
** Block device usb 0 not supported
Wrong Image Format for bootm command
ERROR: can't get kernel image!
stopping USB..
Reset IDE: ide_preinit failed
** No boot file defined **
### JFFS2 loading 'uboot-original-mtd0.kwb' to 0x800000
Scanning JFFS2 FS: ........ read_nand_cached: error reading nand off 0x187f800 size 8192 bytes
read_nand_cached: error reading nand off 0x1881800 size 8192 bytes
read_nand_cached: error reading nand off 0x1883800 size 8192 bytes
read_nand_cached: error reading nand off 0x1885800 size 8192 bytes
read_nand_cached: error reading nand off 0x1887800 size 8192 bytes
read_nand_cached: error reading nand off 0x1889800 size 8192 bytes
read_nand_cached: error reading nand off 0x188b800 size 8192 bytes
read_nand_cached: error reading nand off 0x188d800 size 8192 bytes
read_nand_cached: error reading nand off 0x188f800 size 8192 bytes
read_nand_cached: error reading nand off 0x1891800 size 8192 bytes
read_nand_cached: error reading nand off 0x1893800 size 8192 bytes
read_nand_cached: error reading nand off 0x1895800 size 8192 bytes
read_nand_cached: error reading nand off 0x1897800 size 8192 bytes
read_nand_cached: error reading nand off 0x1899800 size 8192 bytes
read_nand_cached: error reading nand off 0x189b800 size 8192 bytes
read_nand_cached: error reading nand off 0x189d800 size 8192 bytes
read_nand_cached: error reading nand off 0x189f800 size 8192 bytes . done.
### JFFS2 load complete: 524288 bytes loaded to 0x800000
## Starting application at 0x00800200 ...
with usb drive
U-Boot 2011.12 (Apr 18 2012 - 23:08:20)
Seagate GoFlexNet
SoC: Kirkwood 88F6281_A1
DRAM: 128 MiB
WARNING: Caches not enabled
NAND: 256 MiB
In: serial
Out: serial
Err: serial
Net: egiga0
88E1116 Initialized on egiga0
Using egiga0 device
ping failed; host 10.10.10.5 is not alive
Hit any key to stop autoboot: 0
(Re)start USB...
USB: Register 10011 NbrPorts 1
USB EHCI 1.00
scanning bus for devices... 2 USB Device(s) found
scanning bus for storage devices... 1 Storage Device(s) found
Loading file "/rescueme" from usb device 0:1 (usbda1)
** File not found /rescueme
reading /rescueme.txt
** Unable to read "/rescueme.txt" from usb 0:1 **
Creating 1 MTD partitions on "nand0":
0x000002500000-0x000010000000 : "mtd=3"
UBI: attaching mtd1 to ubi0
UBI: physical eraseblock size: 131072 bytes (128 KiB)
UBI: logical eraseblock size: 129024 bytes
UBI: smallest flash I/O unit: 2048
UBI: sub-page size: 512
UBI: VID header offset: 512 (aligned 512)
UBI: data offset: 2048
UBI: attached mtd1 to ubi0
UBI: MTD device name: "mtd=3"
UBI: MTD device size: 219 MiB
UBI: number of good PEBs: 1751
UBI: number of bad PEBs: 1
UBI: max. allowed volumes: 128
UBI: wear-leveling threshold: 4096
UBI: number of internal volumes: 1
UBI: number of user volumes: 0
UBI: available PEBs: 1730
UBI: total number of reserved PEBs: 21
UBI: number of PEBs reserved for bad PEB handling: 17
UBI: max/mean erase counter: 1/1
UBIFS error (pid 0): ubifs_get_sb: cannot open "ubi:rootfs", error -19
Error reading superblock on volume 'ubi:rootfs'!
Loading file "/boot/uImage" from usb device 0:1 (usbda1)
1 bytes read
Found bootable drive on usb 0:1
Loading file "/boot/uImage" from usb device 0:1 (usbda1)
2822232 bytes read
Loading file "/boot/uInitrd" from usb device 0:1 (usbda1)
6114335 bytes read
## Booting kernel from Legacy Image at 00800000 ...
Image Name: Linux-3.17.0-kirkwood-tld-1
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 2822168 Bytes = 2.7 MiB
Load Address: 00008000
Entry Point: 00008000
Verifying Checksum ... OK
## Loading init Ramdisk from Legacy Image at 01100000 ...
Image Name: initramfs-3.17.0-kirkwood-tld-1
Image Type: ARM Linux RAMDisk Image (gzip compressed)
Data Size: 6114271 Bytes = 5.8 MiB
Load Address: 00000000
Entry Point: 00000000
Verifying Checksum ... OK
Loading Kernel Image ... OK
OK
Starting kernel ...
Uncompressing Linux... done, booting the kernel.
Error: unrecognized/unsupported machine ID (r1 = 0x00000c11).
Available machine support:
ID (hex) NAME
ffffffff Generic DT based system
ffffffff Marvell Kirkwood (Flattened Device Tree)
Please check your kernel config and/or bootloader.