Hi,
First of all, this place is great. Learned so much today from this forum.
I was trying to get samba on my pogoplug E02 pink. Followed Qui's blog, but then timestamp were not correct. Tried getting ntp installed didn't work. So decied to go with ArchLinux instead.
Suddenly, out of nowhere, Iost ssh access. Tried de-register and register did not help. Again somewhere on Qui's blog I found the way to get temporarily ssh working with curl thing. That worked.
Then by mistake, I kept following instruction from the same tutorial, which was supposedly for V4 debian installation. The link I followed - http://blog.qnology.com/2014/07/hacking-pogoplug-v4-series-4-and-mobile.html
When I rebooted, pogo didn't come back. Currently these issues are being faced-
1. Does not read USB! Tried HDD as well as flash drivers. HDD doesn't do anything. Flash drives lit up for a sec and go away.
2. Does not show front LED- I am guessing my env is incorrect since I followed V4, hence no LED.
3. Only flashes network LEDs once in a while, I guess. However, no IP assigned if I check my router's DHCP page.
What I tried -
1. Disconnected all drivers and hope to boot from internal flash, didn't help. Did not get an IP address to ssh into.
2. Followed Bodhi's ArchLinux/Debian images on ext3 as well as ext2 formatted flash drivers, did not boot. Again, as I reported above, flash drive light would lit up and go away.
Seems like I've put system in weird mode/setting for v4 so all peripherals stopped working.
Is their an easier way (by booting something) to rescue or do I have to with serial uBoot restore and stuff ?
Any help is highly appreciated. Strarbucks Coffee offered !
Please guide me with correct link/info/steps.
First of all, this place is great. Learned so much today from this forum.
I was trying to get samba on my pogoplug E02 pink. Followed Qui's blog, but then timestamp were not correct. Tried getting ntp installed didn't work. So decied to go with ArchLinux instead.
Suddenly, out of nowhere, Iost ssh access. Tried de-register and register did not help. Again somewhere on Qui's blog I found the way to get temporarily ssh working with curl thing. That worked.
Then by mistake, I kept following instruction from the same tutorial, which was supposedly for V4 debian installation. The link I followed - http://blog.qnology.com/2014/07/hacking-pogoplug-v4-series-4-and-mobile.html
When I rebooted, pogo didn't come back. Currently these issues are being faced-
1. Does not read USB! Tried HDD as well as flash drivers. HDD doesn't do anything. Flash drives lit up for a sec and go away.
2. Does not show front LED- I am guessing my env is incorrect since I followed V4, hence no LED.
3. Only flashes network LEDs once in a while, I guess. However, no IP assigned if I check my router's DHCP page.
What I tried -
1. Disconnected all drivers and hope to boot from internal flash, didn't help. Did not get an IP address to ssh into.
2. Followed Bodhi's ArchLinux/Debian images on ext3 as well as ext2 formatted flash drivers, did not boot. Again, as I reported above, flash drive light would lit up and go away.
Seems like I've put system in weird mode/setting for v4 so all peripherals stopped working.
Is their an easier way (by booting something) to rescue or do I have to with serial uBoot restore and stuff ?
Any help is highly appreciated. Strarbucks Coffee offered !
Please guide me with correct link/info/steps.