Can only access to GoFlex Home 3TB with rescue - need help (11 replies)

GoFlex Home 3TB got semi bricked and I can only access it from a rescue USB flash drive.

I finally got to it and tried to install debian on my GoFlex Home 3TB. I followed Jeff's guide. The wheezy script could not complete and I got the error

FATAL: kernel too old

So I stopped trying with wheezy and succesfully installed squeeze afterwards. Problem was the GoFlex Home wouldn't boot either from the USB flash drive with debian nor without.

This thread and this one, by Gr3yh0und led me into the right direction. I created an a rescue usb using Jeff's rescue system and boot into the rescue system that I got from here.

I'm not really sure what to do from here. Gr3yh0und's guide says it should be easy to install the rescue system into the NAND memory so the wheezy installation can resume from there. However I encounter this error:

rescue:/tmp# wget http://jeff.doozan.com/debian/rescue/install_rescue.sh
Connecting to jeff.doozan.com (50.116.34.13:80)
Connecting to projects.doozan.com (50.116.34.13:80)
install_rescue.sh    100% |******************************************|  8122  --:--:-- ETA
rescue:/tmp# chmod +x install_rescue.sh
rescue:/tmp# ./install_rescue.sh
This script must be run from outside your Pogoplug install or Rescue System.
Please boot from a USB device and try again.

It'd appreciate the help since I'm kind of stuck here. I'm pretty sure the device is not bricked. Also worth mentioning that for every step I've taken, I've not left the 3TB disk connected to the device at all.


My dmesg output: http://pastebin.com/1ZHK96Dj

and fw_printenv gives me this:

rescue:/# fw_printenv
Too few good blocks within range