I have a small stable of E02s but this is my first Pro. I've spent a while in this board and have gotten quite a bit sorted on my own and the Pro boots fine off the microSD in the USB, but I'm at a loss for getting the internal SATA to be recognized. I'm not worrying about booting from the SATA (yet), I just want to read it as a data disk.
I'm using Debian-4.14.180-oxnas-tld-1-rootfs-bodhi.tar.bz2 and I tried using the DTB from this thread, https://forum.doozan.com/read.php?2,101694,101719#msg-101719 but switched back to the one in the rootfs archive when I realized it would be a later version.
I've attached the console boot log where I let it go until it started looping on trying to reset the interface, then unplugged the the SATA drive to let it finish booting.
Any suggestions?
I'm using Debian-4.14.180-oxnas-tld-1-rootfs-bodhi.tar.bz2 and I tried using the DTB from this thread, https://forum.doozan.com/read.php?2,101694,101719#msg-101719 but switched back to the one in the rootfs archive when I realized it would be a later version.
I've attached the console boot log where I let it go until it started looping on trying to reset the interface, then unplugged the the SATA drive to let it finish booting.
Any suggestions?