IconBIT IS608 Oxnas OX820 booting problem with kernel 4.14.x (3 replies)
Hi bodhi. IconBIT IS608 (Oxnas (OX820)) Boots normally from sata-hdd Debian 10 (buster) inclusive until linux-4.4.201-oxnas-tld-1.bodhi On linux-4.14.176-oxnas-tld-1.bodhi and...
View ArticlePOGO-V4-A3-01 + 2017.07 U-Boot Kirkwood + Debian 5.2.9 rootfs (no replies)
I have searched the forum if someone else has had difficulty to access Pogoplug v4 (POGO-V4-A3-01) via ssh as root. I keep getting connection refused from Debian and I have run out of ideas on how to...
View ArticleHowto: pi-hole ad-blocker on Seagate Dockstar (1 reply)
In case this is useful for anyone else, here's my notes on How to install pi-hole 5.0 on Seagate Dockstar running Debian 10 --------------------------------------------------------- This was performed...
View ArticleReducing boot time on NSA325 (3 replies)
Hello, I'm overall satisfied with the performance of my NSA325 + latest u-Boot + Debian on USB flash drive, but one thing that I would like to improve is its boot time. I don't always keep it powered...
View ArticleZyxel NSA325 Debian with stock uboot... LABEL=rootfs does not exist (no replies)
I am trying to boot with stock uboot on Zyxel NSA325 with the Debian 5.2.9 which is installed on a USB stick. I have the serial console attached and I see an error LABEL=rootfs does not exist. The USB...
View ArticleGoflex Home doesn't boot from sata (no replies)
I'm not sure what the problem is, but my GFH never boots from sata normally. I can interrupt uboot and boot into recovery with the net console. When I issue a "reboot now" command from rescue,...
View ArticleWear leveling on one but not another SanDisk Extreme PRO (no replies)
It would appear there are major differences between one version of SanDisk Extreme PRO 32GB and another. Here is the one I should have bought, SDSDXPA-032G-X46 which clearly states there's wear...
View ArticleOwncloud 10 On Debian 10 (1 reply)
I did managed to get Owncloud10 running on a 128Mb Pogoplug with Debian 10 installed.... Based on a proper quality microUSB card (32GB) formatted with one 6GB ext4 primary partition labeled ¨rootfs¨...
View ArticleHelp with booting NSA310S - Linux Kernel 5.7.1 (no replies)
Hi, First of all, thank you bodhi for your hard work for these devices :) I have an old, unused NSA310S in my gardrobe so I decided to try to install Debian on it. I don't want to use a USB drive for...
View ArticleEthernet lost after upgrade Debian Buster on Pogoplug (1 reply)
I installed the last Debian Buster oxnas release, that run perfectly. But then ran update, about 50 files could be upgraded. I ran the upgrade and after that the eth0 if was not initialized . I found...
View ArticleNetgear Stora MS2000 USB flash drives issue (1 reply)
Dear All, I installed new u-Boot and Debian on Netgear Stora MS200 and have a problem with USB flash drives. I tested three USB flash drives, SD card (tried two card readers) and SSD drive. Pretec...
View ArticleFailed to Install latest kernel to NSA310S (2 replies)
Hi! I have an NSA310S on which I would like to install the latest linux kernel (and OMV later), but unfortunately failed. I have updated tha U-boot to the latest and i have only changed the MAC...
View ArticleNAS326 booting problem (no replies)
Hi again bodhi, After the successful installation of your Debian, I am now trying the same for a NAS326. I tried the zyxelOS fw_setenv methods, didn't worked, so decided to go for the serial console....
View ArticleNeed help in restoring u-boot for Netgear Stora MS2110 (no replies)
Hello guys. Could you please help me with some issues I have with a Netgear Stora MS2110? This thing was bricked when I got it. I tried to revive it but the official recovery server is history(very...
View ArticleZyXel NSA325 V1 - Erased NAND what now (2 replies)
Hey all, I was playing with fire and made a fundamental mistake with the command erase nand in uBoot. I am trying to write/flash the uBoot now, but I think I managed to brick it completely. When...
View Articleunusually long boot process (no replies)
Hello Bodhi, I'm using a few Samsung GoFlexNet for years using the jessie based rootfs. Devices are booting by loading uImage, uInitrd and the DTB-file from an usb flashdisk [ U-Boot 2017.07-tld-1...
View ArticleRestore and run from NAND stock (no replies)
Hi dear members! I'd like to restore the stock firmware. I have many confs and files what I created when I did the Debian install. Unfortunately I'm not sure what is what. I dont know if I have mtds...
View Articlensa-325 creating module iscsi_target for 5.2.9 kernel (no replies)
I've hit an issue compiling kernel module for 5.2.9 currently on NSA-325, where it failed with make scripts, then make prepare so could not get to make iscsi_target module I'm generally following...
View ArticlePogoplug Pro SATA, Help Needed (6 replies)
I have a small stable of E02s but this is my first Pro. I've spent a while in this board and have gotten quite a bit sorted on my own and the Pro boots fine off the microSD in the USB, but I'm at a...
View ArticleDebian cannot boot on KD20 after flashing u-boot (1 reply)
I was trying to get a KD20 OMNINAS to boot from USB. At first I managed to use tftp upload of uImage with kd20.dtb appended and uInitrd I could mostly reproduce the events as described in:...
View Article