tfttboot hangs on Stora (3 replies)
Hi everyone. I try to install debian on my old Netgear Stora. I followed instructions from many sites, but now I'm stuck. I've built the uImage for my Stora from...
View ArticleNAS 220 doesn't work with debian install (18 replies)
Hi all, Proud to be in this forum where a lot of experts are. I have a seagate nas220 bricked as someone starts an (official) upgrade and tried to stop it disconnecting power supply connector. I have...
View ArticleNSA310 no uboot update possible and ext2load: "Bad partition 1" (7 replies)
Hello all, after trying for ~4 hours and reading several installation instructions, the installation of Debian is still not working. One stumbling block are bad sectors in the mtd0 partition: / #...
View ArticleMarvell development board (db-mv784mp-gp) cannot start Debian (5 replies)
Compile and generate the u-boot-spl.kwb file using the default configuration of the mainline uboot (version 2017.03), write it to the spiflash and start the log: BootROM 1.20 Booting from SPI flash...
View ArticleBoot from hdd on Stora (4 replies)
Hi all. I am really stuck. Following the guide: HowTo: Stora - Debian Stretch and OMV4 I've been able to boot debian from USB stick. Everything fine. After a few minutes playing with my new debian,...
View ArticleInstalling permanently to remove usb (18 replies)
Hi all, what would be the steps to get the system installed in the "real" boot partition. E.g. for my NSA310 I want the system to be independent of the usb flash drive and instead have it boot from...
View ArticleNSA310 separate rootfs and boot (3 replies)
Hi bodhi, after reading this informative wiki article on booting from HDD, I do not understand how the switch is done to HDD in detail (after step 10), specifically how uboot is configured to find the...
View ArticleNegative temperature and LEDs for NSA310 (5 replies)
Hi all, I have two issues I am trying to figure out with setting up NSA310 after loading debian. 1. the package lm-sensors was installed to check the temperatures with the 'sensors' command. This...
View ArticleSony NSZ-GS7 - serial connection ? (2 replies)
Hello, yesterday i opened an older sony-box. The box is pretty useless with the ancient Android 3 now. There is no convenient way to install another os however (secured bootloader). Because of the...
View ArticleNSA325 Wireguard (6 replies)
Hi, long time no see! ZyXEL NSA325 Linux version 5.13.6-kirkwood-tld-1 (root@tldDebian) (gcc (Debian 8.3.0-6) 8.3.0, GNU ld (GNU Binutils for Debian) 2.31.1) #1.0 PREEMPT Sat Jul 31 22:10:39 PDT 2021...
View ArticleKernel modules and -fno-pic (4 replies)
Has anyone that builds loadable kernel modules run into the requirement for a -fno-pic compiler flag? I have a couple of lkms I created a few years ago and when I went to modify one I suddenly get...
View ArticleIX2 200 no boot log (3 replies)
Hi, I have 2 Lenovo Iomega ix2 200 and they both don't work. One of them blinks only the white LED, the other one blinks white and red LED. I use a FT232 USB to connect - JP1 = 1st empty, 2nd txd, 3rd...
View ArticleNSA325 fstab (2 replies)
Trying to mount specific disks to specific directorys at boot gives me some problems. If the disk isnt connected i cant access the box as ssh gets connection refused. Must the disk be present when...
View ArticlePogo Plug e02 Can't connect over ssh anymore (4 replies)
Hey guys not really sure whats going on. Connected over serial not sure what to do now. Please advise. sudo picocom -b 115200 /dev/ttyUSB0 picocom v3.1 port is : /dev/ttyUSB0 flowcontrol : none...
View ArticlePogoplug V4 can't boot off Verbatim SD card (1 reply)
I'm trying to create a bootable image on a Verbatim SD card (actually, microSD + adapter). I've done this dozens of times with PNY, SD cards, PNY microSD cards and Sandisk microSD cards, but I'm...
View ArticleIs it possible to have a Debian 11 Bullseye build for Pogo Armel? (2 replies)
I have just been experimenting with Gerbera 1.9.2 and now it's passed my testing, I want to tick it on the live system. Arrgh, The dependencies that I had to download from the testing repo have moved...
View ArticleDockstar HW mod: Trying to add native sata (2 replies)
Hi, First I must thank the community, specially Bodhi for supporting the project during all this time! I got a Dockstar about 9 years ago, served me well, however I always wanted to try lifting the...
View ArticleLenovo IX2 stucks at "Starting kernel" (1 reply)
Hello , I am new to ARM linux , I have a Lenovo IX2 box and try to install new version of OS rather than the stock firmware. I try to follow the guide...
View ArticleChange bootargs in uboot (2 replies)
Hi Bodhi, Hi @All, I recently updated my Thecus N2350 to Debian Bullseye as well as the newest kernel 5.14.9. Working fine as always, thanks! I do now have some problems with Docker and cgroups v2 and...
View ArticleNewEgg: Seagate BarraCuda ST2000DM008 2TB 7200 RPM 256MB Cache SATA 6.0Gb/s...
Currently, NewEgg is selling this Seagate BarraCuda ST2000DM008 2TB 7200 RPM 256MB Cache SATA 6.0Gb/s 3.5" Hard Drive Bare Drive US $49.99 + Free S/H. This offer will expire withing 20 hours as of...
View Article