Bodhi Debian and SanDisk ReadyCache (3 replies)
I started a separate thread since the original thread where I found it was getting into troubleshooting a specific user's problem. For the record, I found this issue here I have a Pogo-E02 (pink). I...
View ArticleCold Boot works but reboot does not - Try this (no replies)
I want to promote this potential solution from RomanG: QuoteSo I again reduced bootdelay variable from 10 sec to 2 sec and now it boots consistently from either cold reboot or warm reboot. from this...
View ArticleHow To Install PBX With GUI (no replies)
Any one have an up to date guide for installing a PBX with a GUI. A long time ago I tried Asterisk with FreePBX but ran in to trouble with FreePBX and could not get it resolved. Thanks
View ArticleCompositor pf 10.003 (no replies)
I have a couple of the Compositor 10.003 gs dpfs and I'm looking to use them for a custom display. They look like this http://i.imgur.com/dXoG906.jpg The problem I'm having is that there seems to be...
View ArticleGoflex Home Semi Bricked (no replies)
Hello I´m new in the forum i´m from portugal so sorry for my poor english I have a goflex home 1tb and i try to put archlinux on but someting wrong, dont boot the green light blink and dont boot, i...
View Articlepogoplug-E02 broken how to fix to boot then install debian (9 replies)
Been trying to get debian to boot on a pogoplug E02. Right now I have no network ip show up and have a usb serial cable ... below is a dump of output from serial output on power up ... what are the...
View ArticleAutomount USB drives (9 replies)
Is it possible to remove usb drive without unmounting and plug it back again so it'll get mounted again to the same share? Created udev rule so my usb drive always appears as /dev/myntfs. I've been...
View ArticleChange device ordering when booting from usb (3 replies)
physical drive "dev" ordering when booting from usb versus sata drive. If I boot from the left sata drive with a matching drive in the right drive bay the left drive is /dev/sda and the right drive...
View ArticleKirkwood U-boot - Getting all supported Kirkwoods on-board (4 replies)
@bohdi @davygravy Gents, Shall we work on getting all known and linux supported Kirkwood based boards into one tree, especially those that we don't have an existing consolidated codebase? Get these...
View ArticleConditionally boot with PogoPlug original U-boot? (no replies)
Hi, I've figured out that if I write my NetBSD kernel into the 8 meg to 16 meg section of a PogoPlug Mobile's flash (the area referred to as "failsafe"), the PogoPlug's GNU/Linux can still boot just...
View Articlereverse brick? (2 replies)
Hi, I have a pogo E02 that I can only boot with a USB stick. If I remove the usb stick and wifi dongle and plug in the ethernet cable the LED never lights up. I cannot boot into the rescue system. I...
View ArticleHow does Transmission work with non-uPnP router? (2 replies)
Hey guys, I'm on the road, and carrying the Dockstar with me. I'm at a hotel where the router has uPnP disable (I believe so last time I checked). I also have a travel wifi router with me and plug it...
View Article[libst2205] HighBox Apache 2.4" hack problems (2 replies)
Hi, I'm trying to hack a new DPF. It's a HighBox Apache 2.4". It looks like Perl one, but is was a different different. Hardware detection user@ubuntu:~/st2205u/libst2205$ dmesg (...) [3261252.416745]...
View ArticleDebian Transmission with non-uPnP router (no replies)
I'm looking for information about Bittorrent Transmission in this thread: http://forum.doozan.com/read.php?8,14756 TIA
View ArticleCan't boot from SATA after power fail goes into Rescue (8 replies)
I have a system that typically boots into an ext3 Hard Drive (should allow it to survive power failures), but now will only boot into the rescue system. When I try to do anything on /dev/sda it says...
View Articleupgrading libapt-4.12 breaks everything (no replies)
I have installed Debian squeeze on my Seagate dockstar,a while ago then successfully upgraded with apt-get to wheezy (7.1) last July. Now I'm trying to upgrade to 7.3. There about 40 packages that...
View ArticleAn Important Role in a Wedding Ceremony - Flower Girl (no replies)
I think that maybe everyone has an experience of attending a wedding ceremony. Am I right? As for a wedding ceremony, in addition to the bride and the bridegroom, the bridesmaid and the groomsman also...
View ArticleUpdate broke dependencies - samba no longer available (no replies)
I have been running Debian Wheezy on my pink PogoPlug for a year or so now and just recently samba quit working and I can't seem to get it installed again. I don't know if it was an update that I...
View ArticlePogo v2, wheezy on stick + additonal usb3.0 hdd. how? (2 replies)
Hi, what happend till now: I installed debian squeeze with the dockstar script on 2gb usbstick (mounted to a pogo e02) and upgraded it with apt-get to wheezy. on the nand I installed the rescue system...
View ArticleUse NSA325 as tvheadend backend with USB dvs-s2 receiver (1 reply)
Dear all, my intention is to use the NSA325 as tvheadend backend with an USB attached dvb-s2 receiver. Compiling tvheadend was straight forward, but it seems that there are no dvb-s/s2 modules...
View Article